Download Print this page

Timer Programming; End Of Programme; Switching Off The Appliance; Interrupting The Programme - Siemens SC76M530GB Operating Instructions Manual

Hide thumbs


Timer programming *

* depending on model
You can delay the start of the programme
in 1-hour steps up to 24 hours.
– Close the door.
– Switch on ON/OFF switch (.
– Press button 8 + until the digital
display h jumps to :
– Press 8 + or – button until the
displayed time corresponds with your
– Press START button H, timer
programming is activated.
– To delete timer programming, press
the 8 + or – button until h :
indicated on the digital display.
You can change your programme
selection at any time until the
programme starts.

End of programme

The programme has ended when the
value :
is indicated on the numerical
display h.

Switching off the appliance

Short time after the end of the programme:
– Switch off ON/OFF switch (.
– Turn off the tap (not applicable if Aqua-
Stop fitted).
– Remove the utensils when they have
cooled down.
At the end of the programme please open
the door fully and not partially when
emptying the dishwasher. Any escaping
water vapour could damage sensitive

Interrupting the programme

– Switch off ON/OFF switch (.
– To continue the programme, switch on

Terminating the programme

– Press START button H for
– The programme sequence lasts
– Switch off ON/OFF switch (.

Changing the programme

When the START button H has been
pressed, the programme cannot be
The only way a programme can be
changed is by Cancel programme (Reset).
The LEDs go out. The programme is
If the door was opened on an
appliance which has a warm water
connection or is heated, first leave the
door ajar for several minutes and then
close. Otherwise, expansion (pressure)
may cause the appliance door to
spring open or water to run out of the
the ON/OFF switch ( again.
approx. 3 sec.
The numerical display h
indicates :
approx. 1 min. On the digital
display h is indicated :



This manual is also suitable for: