Mini Specs Power Connection Kits And Nomenclature - GE 6100 Series Data Manual

Power Connection Kits
230/208-Volt Line Cord Connection Units
Electric
Line Cord
Heat
Kit
BTUH
RAK3153A 8150/7900
RAK3203A 11200/10900
RAK3303A 16000/15450
Electric Heat Amps include electric heater and fan motor current draw.
Each Line Cord Kit has an integral Leakage Current Detection and Interruption (LCDI) or Arc Fault
Current Interrupter (AFCI) device as required by National Electrical Code (NEC) and Underwriters
Laboratories (UL) for units manufactured after August 1, 2004.
265-Volt Sub-Base and Direct Connected Units
Power
Sub-Base
Connection Kit
RAK204E15 RAK5172
RAK204E20 RAK5202
RAK204E30 RAK5302
Electric Heat Amps include electric heater and fan motor current draw.
265-volt units are to be permanently connected in compliance with National Electrical Code and local codes and have a factory-installed junction box on the chassis.
Each 265-volt sub-base kit consists of sub-base with appropriate receptacle for minimum circuit amperage, chaseway to route power connector from sub-base to chassis
and wiring to connect sub-base to building wiring.
265-Volt Power Connection Kit must be ordered separately.
Important
Essential Elements Ordering Overview
230/208-volt line cord connected units — order line cord kit
230/208-volt sub-base connected units — order sub-base
265-volt units — order sub-base and power connection kit
Zoneline Chassis Nomenclature
®
The Zoneline chassis is identified by a model number defining the type of unit, cooling capacity, electrical information and
optional features included on the unit. When specifying or ordering the Zoneline chassis, the use of this nomenclature will
assure receiving the correct unit.
EXAMPLE
A Z 6 1 H
Zoneline Chassis series
packaged 41= deluxe line cool/
terminal electric heat
61=deluxe line heat pump
chassis
Unit type
E= cooling with electric
resistance heat
H= heat pump with electric
resistance heat
Electric Electric Min. Circuit
Protection
Heater Heat
Watts Amps (Amps)
2400/2320 11.0/11.6
3300/3200 15.1/16.0
4700/4530 21.2/22.4
Direct
Connection Kit
RAK5157
RAK5207
RAK5307
1 2 D A
Nominal cooling capacity Universal
power connection
07=7,000 BTUH cooling
09=9,000 BTUH cooling
12=12,000 BTUH cooling
15=15,000 BTUH cooling Special Features
B=base unit
C=corrosion treated
Voltage/Phase/
D= internal
Frequency
condensate
D= 230/208-Volt,
removal (ICR)
single-phase, 60 Hz
system (heat
E= 265-Volt, single-phase,
pump models
60 Hz
only) (not for
coastal areas)
P= Dry Air 25 (4100
Series only)
230/208-Volt Sub-Base and Direct Connected Units
Direct
Sub-Base Connection
Kit
15 RAK204D15P RAK4157
20 RAK204D20P RAK4207
30 RAK204D30P RAK4307
Electric Heat Amps include electric heater and fan motor current draw.
Units connected through sub-base do not require an LCDI or AFCI device since they are not
considered to be line-cord connected. Each 230/208-volt sub-base kit consists of sub-base with
appropriate receptacle for minimum circuit amperage, chaseway to route power connector from
sub-base to chassis, wiring to connect sub-base to building wiring and a short line cord with 9-pin
connector to connect to chassis and plug into receptacle in sub-base.
Short sub-base line cord may not be used without sub-base.
Junction box for 230/208-volt chassis must be purchased separately.
RAK4002A for 2900, 3900, 4100, and 6100 series units, RAK4002B for 5800 series units.
Electric Heat Electric Heater
BTUH Watts
8150 2400
11550 3400
16350 4800
D
geappliances.com
Electric Electric Electric
Heat Heater Heat
BTUH Watts Amps
8150/7900 2400/2320 11.0/11.6
11200/10900 3300/3200 15.1/16.0
16000/15450 4700/4530 21.2/22.4
Electric Heat Min. Circuit Protection
Amps
9.6
13.3
18.6
Min. Circuit
Protection
(Amps)
15
20
30
(Amps)
15
20
30
3