Chapter 5. Configuring The Server; Using The Setup Utility Program; Starting The Setup Utility Program; Viewing Information In The Setup Utility Program - Lenovo 70AL Maintenance Manual

Chapter 5. Configuring the server

This chapter provides the following information to help you configure the server:
• "Using the Setup Utility program" on page 47
• "Using the ThinkServer EasyStartup program" on page 54
• "Configuring RAID" on page 57
• "Configuring the Ethernet controllers" on page 62
• "Updating the firmware" on page 62

Using the Setup Utility program

This topic provides information about using the Setup Utility program.
The Setup Utility program is part of the server firmware. You can use the Setup Utility program to view and
change the configuration settings of your server, regardless of which operating system you are using.
However, the operating system settings might override any similar settings in the Setup Utility program.

Starting the Setup Utility program

This topic provides instructions on how to start the Setup Utility program.
To start the Setup Utility program, do the following:
1. Connect the server to an ac power source and press the power button on the front panel to turn on the
server. See "Turning on the server" on page 45.
2. Press the F1 key as soon as you see the logo screen. Then, wait for several seconds, and the Setup
Utility program opens. If you have set a password, you need to type the correct password to enter the
Setup Utility program. For password information, see "Using passwords" on page 51.

Viewing information in the Setup Utility program

The Setup Utility program menu lists various items about the system configuration. Select a desired item
to view information or change settings.
When working with the Setup Utility program, you must use the keyboard. The keys used to perform various
tasks are displayed on the right bottom pane of each screen. You also can press the F1 key for general help
about the keys. For most items, the corresponding help message is displayed on the right top pane of the
screen when the item is selected. If the item has submenus, you can display the submenus by pressing Enter.
You can view the following information about your specific server model from the Setup Utility program:
• The Main menu lists information about the BIOS version, microprocessor type and core frequency,
memory size, installed SATA devices, and system date and time.
• The Advanced menu lists information about the installed microprocessor and its supported technologies.

Setup Utility program interface

This topic provides information about the menus and items in the Setup Utility program.
Depending on the version of your system BIOS, some menu or item information might differ slightly from the
information in this topic. The information in this topic is based on the 0.9b version of the BIOS.
© Copyright Lenovo 2013 47