1. Manuals
  2. Brands
  3. Lanzar Manuals
  4. Crossover
  5. OPTIX-9
  6. Owner's manual

Lanzar OPTIX-9 Owner's Manual

Digital bass enhancer
Hide thumbs
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual
DIGITAL BASS
ENHANCER

Advertisement

Table of Contents
loading

Related Manuals for Lanzar OPTIX-9

Summary of Contents for Lanzar OPTIX-9

  • Page 1 DIGITAL BASS ENHANCER...
  • Page 2 Bass Maximizer Indicator: Not only does The OptiX-9 provide good music to your ears, but it also gives you some visual enjoyment as well. On the Chassis of the OptiX-9, there are two LED indicators that flashes when the bass maximization circuit is activated.
  • Page 3 FUNCTIONS THE OUTSIDE 1. Inputs: The inputs of The OptiX-9 use a balanced input circuit to help minimize induced noise. They are also designed to handle very high signal voltages up to 15 volts. 2. Outputs: These RCA connectors should be connected to the next component after the OptiX-9, such as a crossover, equalizer, or amplifier.
  • Page 4 10. Input Grounding: For most systems you can leave this jumper set in the BALANCED position. In some systems, the source unit may look for a ground through the RCA connectors. In this event, you should go ahead and change the jumpers to the UNBALANCED position.

  • Page 5: Power Connection

    Power connection B+(12V) : Connect a red wire to the car battery or other power source. REMOTE: Connect an orange wire to remote activating (12V DC)wire of car stereo or equalizer. : Connect a black wire to the car chassis for ground connection. - 4 -...

  • Page 6: Signal Connection

    ",,··",·1-\-1, Crossover SUIIWOOFER NOTE: For signal connection, the output RCA connectors should connected to the next component after the OptiX-9, such as a crossover, equalizer, or amplifier. Just remember, the OptiX-9 should go inline before a crossover. - 5 -...

  • Page 7: Specifications

    (3) The music on the tape (4) Speakers and speaker enclosures. Because of the variations in the recording process, we developed OptiX-9 to help restore any low frequencies lost during the recording process, however, the acoustics of various environments are different.

  • Page 8: Troubleshooting Guide

    TROUBLE SHOOTING GUIDE If the Unit does not turn-on, and /or the power indicator LED is NOT illuminated, do this : 1) Check and make sure that B+ and GND are not reversed 2) Check that all power wires are properly connected and has the appropriate potential (11-16 volts) 3) Check that the fuse is intact.

Table of Contents