GE Triton Profile GSD5610 Owner's Manual page 23

Problem
Dishes don't dry
Control panel
responded to inputs
but dishwasher never
filled with water
Dishwasher won't run
Steam
Sanitized light does
not illuminate at the
end of the cycle
Possible Causes
Low inlet water
temperature
Rinse agent dispenser
is empty
Door latch may not be
properly seated
Fuse is blown, or the
circuit breaker tripped
This is normal
The door was opened
and the cycle was
interrupted during or
after the main wash
portion
The incoming water
temperature was too low
What To Do
Make sure inlet water
•
temperature is correct
(see page 12).
Select SPEED DRY.
•
Check the rinse agent
•
dispenser.
Call for service.
•
Replace fuse or reset
•
circuit breaker. Remove
any other appliances from
the circuit.
Try resetting the
•
START/RESET pad.
Steam comes through
•
the vent by the door latch
during drying and when
water is being pumped out.
Do not interrupt the cycle
•
anytime during or after
main wash.
Raise the water heater
•
temperature to 120°F.
23