Download  Print this page

GE Triton Profile GSD5610 Owner's Manual page 21

Ge appliance dishwashers owner's mannual
Hide thumbs

Advertisement

Table of Contents
Problem
Dishes and flatware
not clean
Spots and filming
on glasses and
flatware
Possible Causes
Low inlet water
temperature
Water pressure is
temporarily low
Air gap is clogged
Improper rack loading
Extremely hard water
Low inlet water
temperature
Overloading the
dishwasher
Improper loading
Old or damp powder
detergent
Rinse agent dispenser
empty
Too little detergent
What To Do
Make sure inlet water
temperature is correct
(see page 12).
Turn on a faucet. Is water
coming out more slowly
than usual? If so, wait until
pressure is normal before
using your dishwasher.
Clean the air gap.
Make sure large dishware
does not block the
detergent dispenser or the
wash arms.
®
Use Jet-Dry
rinse agent to
remove spots and prevent
new film buildup.
To remove stubborn spots
and pre-existing film from
glassware:
1 Remove all metal utensils
from the dishwasher.
2 Do not add detergent.
3 Select the longest cycle.
4 Start the dishwasher and
allow to run for 18 to 22
minutes. Dishwasher will
now be in the main wash.
5 Open the door and pour
2 cups (500 ml) of white
vinegar into the bottom of
the dishwasher.
6 Close the door and allow
to complete the cycle.
If vinegar rinse doesn't
work: Repeat as above,
except use 1/4 cup (60 ml)
of citric acid crystals
instead of vinegar.
21

Advertisement

Table of Contents
loading

  Also See for GE Triton Profile GSD5610