About The Dishwasher Control Panel - GE Triton Profile GSD5610 Owner's Manual

About the dishwasher control panel.

3
Options
The light above the selected pad will be ON to indicate which OPTION has been selected.
POWER For use with heavily soiled and/or dried-on, baked-on soils. This option MUST be
PRESOAK selected PRIOR to starting the cycle. This option adds 16 minutes to the
SPEED DRY Shuts off the drying heat option. Dishes air dry naturally and energy is saved. You
OFF
SPEED DRY Turns the heater on for fast drying. This cycle will extend the time to your wash
ON
LOCK When the LOCK pad is touched twice within 3 seconds, all pads become inoperative.
DELAY START You can delay the start of a wash cycle for up to 8 hours. Press the DELAY START
RESET To change a cycle after washing starts, touch the START/RESET pad to cancel
4
Start
Close and latch the door. Touch the START/RESET pad to begin the cycle. Water
fill begins, and approximately 40 seconds later the wash action begins.
NOTE: The dishwasher remembers your last cycle so you don't have to reprogram
each time. When the dishwasher is loaded and the door latch is in the locked
position, the control panel lights will be ON and display the last settings you
selected.
If you don't want to change any of the settings, simply touch the START/RESET
pad to begin the cycle.
Also, if a power failure occurs, NORMAL and SPEED DRY will automatically be
programmed. Make any new selections and touch the START/RESET pad to begin
the cycle.
5
Clean
This light is illuminated when a wash cycle is complete. The light will stay ON
until the door is opened.
10
cycle time.
can prop the door open after the CLEAN light illuminates.
cycle by 23 minutes for the NORMAL cycle and 30 minutes for the SANI WASH
cycle. NOTE: Cannot be selected with RINSE ONLY cycle.
You can lock the controls to prevent any selections from being made. Or you can lock the
controls after you have started a cycle or selected DELAY START so the cycle or DELAY
START is not interrupted.
Children cannot accidentally start dishwasher by touching pads with this
option selected.
To unlock the dishwasher after it has been locked, touch the LOCK pad twice within
3 seconds. The light above the LOCK pad will turn off.
pad to choose the number of hours you want to delay the start of the cycle. The
machine will count down and start automatically at the correct time. Pressing the
START/RESET button will cancel the DELAY START selection.
NOTE: If you forget to latch the door a reminder signal will beep until you do so.
the cycle. After water is pumped out and the motor stops, you can reprogram
and restart the dishwasher. This will take approximately 90 seconds.