Errata - System Management - ADTRAN NetVanta 7000 Series Release Notes

NetVanta 7000 Series Release Notes R10.8.1
• Incoming SIP trunk calls that were locally transferred would stop remote ringback during any subsequent
coverage.
• A 503 Service Unavailable response was received when attempting to edit a trunk account.
• The NetVanta 7100 rebooted when attempting a transfer during heavy call loads.
• Hot desking configuration files only supported the use of the default VLAN 2 IP address, 10.10.20.1.
• Click-to-Dial calls in a NetVanta BCS configuration were not being dialed.
• TFTP client connections caused memory to be lost and not recovered.
• Attempting to use a pickup group to pick up a call queue resulted in the call being dropped.
• When an external call was transferred to an internal extension which was configured for coverage to an
external number, the diversion header was missing when the call was routed back out to the external
number.
• An inbound ring group call that was cleared too quickly resulted in a reboot.
• When Music-on-Hold was set to external, Polycom IP phones were not able to blind transfer a call.
• Under heavy call load it was possible that successive calls could use the same memory location to store
their B-channel information, which caused a reboot when the latter call disconnected.
• Enabling VQM caused audio to be lost when using the Simple Remote Phone feature.

Errata - System Management

The following is a list of System Management errata that still exist in
• The NetVanta 7100 and NetVanta 6355 platforms will fail to reset QoS map statistics for applied QoS
maps when the clear counters command is executed.
• When adding a new user account, the GUI may incorrectly display an FXS port as available when it is
already assigned.
• The CLI command, no description, cannot be used to remove a description from a ring group
configuration.
• If an attempt is made to configure greater than the maximum number of call queues, an error will be
shown. Following this error, no call queue configuration commands can be entered until the configuration
mode is exited.
• The Startup Wizard does not present an error message if an invalid VLAN ID is entered when configuring
the Data and Voice VLAN tags.
• An HTTP timeout does not output the correct string in the CLI. Instead a %s is substituted.
• Adding a description to a status group on the Status Groups menu of the GUI may result in a 503 Service
Unavailable response.
• After upgrading from A4.X or A5.X to R10.2 or later the GUI does not highlight Polycom IP 550/560
phones to indicate the phone configuration requires updated.
• When creating a new user in the GUI, DID numbers and aliases are not saved if the Edit Config button is
pressed followed by the Apply button.
• When using the GUI to configure voicemail notification for a user, the times midnight and noon are
mistakenly swapped.
• After a pickup group has been created, the pickup extension and description cannot be modified.
Copyright © 2013 ADTRAN, Inc.
Errata - System Management
AOS version R10.8.1
.
10