Other Features; Set Alarm Timer; Set Sleep Timer - Philips AJ7030D User Manual

6 Other features

Set alarm timer

Set alarm
In standby mode, you can set two alarms to ring
at different time.
Note
•
Make sure that you have set the clock correctly.
1
Press and hold AL1/AL2 for two seconds
to activate alarm setting mode.
» The hour digits and alarm icon begin
to blink.
2
Press TUNING +/- or
hour.
3
Press AL1/AL2 to confirm.
» The minute digits begin to blink.
4
Repeat steps 2 to 3 to set the minute and
alarm volume.
Select alarm source
Adjust AL1/2 iPhone·RADIO·BUZZ control to
select alarm source for both alarms.
/ to set the
Note
•
When alarm time comes, the selected radio, buzzer, or
iPod/iPhone turns on.
•
You can only select the same alarm source for Alarm
1/ Alarm2.
•
If iPhone is selected as alarm source, while no iPod/
iPhone is connected, the clock radio switches to buzzer
source instead.
Activate/deactivate alarm timer
1
Press AL1/AL2 to view alarm settings.
2
Press AL1/AL2 again to activate or
deactivate the alarm timer.
or is displayed if alarm timer is
»
on and disappears if it is off.
To stop the ringing alarm, press the
corresponding AL1/AL2.
» The alarm repeats ringing for the next
day.
Snooze alarm
When alarm sounds, press SNOOZE.
» The alarm snoozes and repeats ringing
nine minutes later.
To adjust alarm interval (in minutes), press
SNOOZE repeatedly.

Set sleep timer

This clock radio can switch to standby mode
automatically after a preset period.
Press SLEEP repeatedly to select the sleep
timer period (in minutes).
» When the sleep timer is activated,
is displayed .
To deactivate the sleep timer, press SLEEP
repeatedly until [OFF] (off) is displayed.
15 30 60
OFF
90 120
EN
11