GE PROFILE GLD6900 Owner's Manual page 5

SPEED CYCLE
(on some models
CHINA
GLASSES
(on some models
RINSE ONLY
28.41(7.5gal.),35 min,
This cycle is for everyday dishes and glassware.
28.41(7.5gal.),35 min.
This cycle is for lightly soiled china and crystal.
28.41(7.5gaL),35 min.
This cycle is specifically designed for glasses.
9.51(2.5 gal.), 10 min.
For rinsing partial loads that will be washed later Do not use detergent with this cycle.
NOTE:TheCHINA (somemodels) selectoris a toggle pad; toggle the pad until the desired cycle is indicated.
NOTE:This dishwasher is equipped with a Cleongensor" with automatic temperature control, therefore,cgcle
length and time mog varg depending on soil and temperature conditions.
NOTE:Onlg the Anti-Bacteria cgcle has been designedto meet the requirements of Section 6, NSF184 for soil
removal and sanitization effioocg.
D Options
The light above the selected pad will be ON to indicate which OPTION has been selected,
PREWASH For use with heavily soiled and/or dried-on, baked-on soils. This option MUST be
(on some models) selected PRIORto starting the cycle, This option adds 16 minutes to the cycle time,
NOTE:Cannot be selected with RINSEONLY cycle,
HEAT DRY Shuts off the drying heat option. Dishes air dry naturally and energy is saved. For
Light OFF faster air dry, you can prop the door open after the CLEAN light illuminates.
HEAT DRY Turns the heater on for fast drying. This will extend the time to your wash cycle by 8
Light ON minutes for the SPEEDCYCLEand 30 minutes for all other cycles. NOTE: Cannot be
selected with RINSEONLY cycle.
LOCK
You con tack the controls to prevent ang selections from being mode. Or gou con tack
the controls after gou hove started a cgcle.
Children cannot accidentallg start dishwasher bbl touching pods with this option
selected.
To unlock the dishwasher controls, touch and hold the HEAT DRY pad for 3 seconds.
The light above the LOCKpad will turn off. To lock the dishwasher, touch and hold the
HEAT DRY pad for 3 seconds. The light above the LOCK pad will turn on.
ADDED HEAT or When selected, the cycle will run longer with heating elements on to improve both
EXTRAHOT WASH wash and dry performance, NOTE: Cannot be selected with RINSE ONLY cycle.
(on some models)
DELAY HOURS You can delay the start of a wash cycle for up to 9 hours. Touch the DELAYpad to
choose the number of hours you want to delay the start of the cycle; then touch
START/RESET. The machine will count down and start automatically at the correct time.
Touching START/RESET clsecond time will cancel the DELAYSTARTselection. NOTE:
If you forget to fully close the door, a reminder signal will beep until you do so.
RESET
To change a cycle after washing starts, touch the START/RESET pad to cancel the
cycle. The START/RESET light will flash while the water is pumped out if needed. This
takes approximately 90 seconds. When the light stops flashing, the dishwasher
can be reprogrammed and restarted.