Troubleshooting Tips - GE PROFILE GLD6900 Owner's Manual

Caring for the dishwasher.
Cleaning the Control Panel
To clean the control panel, use a lightly
dampened cloth. Then dry thoroughly.
Protect Against Freezing
If your dishwasher is left in an unheated
place during the winter, ask a service
technician to:
H-] Cut off electrical power to the
dishwasher Remove fuses or trip
circuit breaker
r-2-iTurn offthe water supply and disconnect
the water inlet line from the water valve.
r_ Drain water from the water inlet line
and water valve. (Usea pan to catch
the water)
E] Reconnect the water inlet line to the
water valve.
Air gap
Does Vour Dishwasher Have an Air Gap?
An air gap protects your dishwasher
against water backing up into it if a drain
clogs. The air gap is not a part of the
dishwasher It is not covered by your
warranty. Not a!l plumbing codes require
air gaps, so you may not have one.
The air gap is easy to clean.
m Turn off the dishwasher and lift off the
cover.
[]Remove the plastic cap and clean with
a toothpick.
Before you call for service...
Troubleshooting Tips
Save time and money! Review the charts on the following pages,
_ or visit www.geappliances.ca. You may not need to call for service.
Error Messages Possible Causes What To Do
START/RESET status You have pressed the • Press the START/RESET padonceto start thedishwasherPress the
indicator light flashing START/RESET pad while the START/RESET pad a secondtime whenthe dishwasher i s runningonlyif you
dishwasher is running. This will wish to cancel the cycle.
cancelthe cycle.The light will
stop flashingafter the dishwasher
drains (about90 seconds).
Powerto the dishwasherwas • Thelightwill stopflashingafterthe dishwasher d rains.A newcyclewill
turned offwhile a cyclewas start automatically.
running and powerhasjust been
restored to the dishwasher.The
blinkinglights indicate that the
dishwasherisdrainingthe potential
water inside.
Dishwasher BEEPS This is a reminderthat gout • Close and latchthe door after openingit mid-cycle.
onceevery 30 seconds dishwasher door has been left
openduring operation.It will
continuebeeping until you close
the door.
12