Basic Operations - Kenwood TK-2260EX Instruction Manual

Your dealer can program your transceiver with Conventional
Group, Voting, Voting with Signaling, or Free Channel Call.
TRANSMITTING
1 Turn the Power switch/ Volume control clockwise to
switch the transceiver power ON.
• A beep sounds if enabled by your dealer.
2 Rotate the Channel selector to select your desired
channel.
• In Voting, Voting with Signaling, and Free Channel Call, the
channel is selected automatically.
3 In Conventional groups, press the key programmed as
Monitor or Squelch Off to check whether or not the
channel is free.
• If the channel is busy, wait until it becomes free.
4 Press the PTT switch and speak into the microphone.
Release the PTT switch to receive.
• For best sound quality at the receiving station, hold the
microphone approximately 3 ~  cm (.5 inches) from your
mouth.
• In Voting and Voting with Signaling, the transceiver will search
for the closest repeater and transmit using that repeater's
frequency.
• In Free Channel Call, the transceiver will search for a free
channel and will begin transmitting on that channel.
Note: When the battery pack voltage becomes too low, transmission
will stop and an alert tone will sound.

BASIC OPERATIONS