Ethernet Connection; Base Set-Up; Telephone Cable Connection - GE InfoLink 28320xx2 User Manual

CAUTION: To reduce risk
of personal injury, fire, or
damage use only the
-22 power adaptor
listed in the user's guide.
This power adaptor is
intended to be correctly
orientated in a vertical or
floor mount position.
IMPORTANT: Do not
connect the telephone
line until the handset is
fully charged. The base
must be plugged into the
AC power at all times.
INSTALLATION NOTE:
Your InfoLink is designed
for home use and will
work with most any
standard Internet system
(non-commercial, non-
corporate environments/
applications). This includes
wired and/or wireless
routers which provide
additional "hard" Firewall
security functionality (HTTP
Internet traffic transmits
inbound and outbound via
Port 80, which is typically
open on most firewall set
ups). However, this unit
may not function properly
behind a firewall that
does not allow http traffic
inbound and outbound on
Port 80.
The unit will not work
with a dial-up internet
connection.

Base Set-Up

The base needs a direct access connection to the
internet, and the IP address of the base must be
provided by a DHCP server.

ETHERNET Connection

1. Using the ETHERNET cable (RJ45 ) provided with
your phone, connect the cable to your broadband
modem or router with cable access.
2. Connect the other end of the cable to the base
ETHERNET port.

Telephone Cable Connection

To use the phone as standard telephone:
1. Plug one end of the telephone line cord into the
PHONE jack on the back of the base and the other
end into a modular jack.
Installation