Ipv6 6To4 Tunnel - NETGEAR N150 DGN1000v3 User Manual

IPv6 6to4 Tunnel

The remote relay router is the router to which your modem router creates the 6to4 tunnel.
Make sure that the IPv4 Internet connection is working before you apply the 6to4 tunnel
settings for the IPv6 connection.

To set up an IPv6 Internet connection by using a 6to4 tunnel:
1. Select ADVANCED > Advanced Setup > IPv6.
2. From the Internet Connection Type menu, select 6to4 Tunnel.
The screen adjusts:
The modem router automatically detects the information in the following field:
• Router's IPv6 Address on LAN1. This field shows the IPv6 address that is acquired
for the modem router's LAN interface. The number after the slash (/) is the length of
the prefix, which is also indicated by the underline (_) under the IPv6 address. If no
address is acquired, the field displays Not Available.
3. Configure the remote 6to4 relay router settings by selecting one of the following radio
buttons:
• Auto. Your modem router uses any remote relay router that is available on the
Internet. This is the default setting.
• Static IP Address. Enter the static IPv4 address of the remote relay router. Your IPv6
ISP usually provides this address.
N150 Wireless ADSL2+ Modem Router DGN1000v3
Advanced Settings
122