Troubleshoot With The Leds; Power Led Is Off Or Blinking; Power Led Stays Red - NETGEAR N600 DGND3700v2 User Manual

N600 Wireless Dual Band Gigabit ADSL2+ Modem Router DGND3700v2

Troubleshoot with the LEDs

After you turn on power to the wireless modem router, the following sequence of events
should occur:
1. When power is first applied, verify that the Power LED
2. Verify that the Power LED turns red within a few seconds, indicating that the self-test is
running.
3. After approximately 30 seconds, verify that:
• The Power LED is solid green.
• The Internet LED is on.
• A numbered Ethernet port LED is on for any local port that is connected to a
computer. This indicates that a link has been established to the connected device.
The LEDs on the front panel of the wireless modem router can be used for troubleshooting.

Power LED Is Off or Blinking

• Make sure that the power cord is securely connected to your wireless modem router and
that the power adapter is securely connected to a functioning power outlet.
• Check that you are using the 12V DC, 2.5A power adapter that NETGEAR supplied for
this product.
• If the Power LED blinks slowly and continuously, the wireless modem router firmware is
corrupted. This can happen if a firmware upgrade is interrupted, or if the wireless modem
router detects a problem with the firmware. If the error persists, you have a hardware
problem. For recovery instructions, or help with a hardware problem, contact technical
support at www.netgear.com/support.

Power LED Stays Red

When the wireless modem router is turned on, the Power LED turns red for about 20 seconds
and then turns green. If the LED does not turn green, the wireless modem router has a
problem.
If the Power LED is still red one minute after you turn on power to the wireless modem router:
1. Turn the power off and back on to see if the wireless modem router recovers.
2. Press and hold the Restore Factory Settings button to return the wireless modem
router to its factory settings. See
If the error persists, you might have a hardware problem and should contact technical
support at www.netgear.com/support.
Factory Settings on page 142.
Troubleshooting
132
is on.