Table of Contents
Advertisement
Make sure that your computer's configuration is compatible with DIGICADRE. Software
incompatibilities or hardware conflicts can arise when connecting. TELEFUNKEN can not
in any case be held responsible if the configuration does not conform.
The USB 2.0 port offers the optimal transfer speed, however DIGICADRE will also work
with a USB 1.1 port. In this case the following message may appear when connecting
DIGICADRE to the PC:
"This device can perform faster if you connect it to a high-speed USB port"
Make sure to keep this in mind.
Turn on the computer, leave the DIGICADRE turned on.
Connect the small USB connector cable to DIGICADRE. Check that it is well connected.
Connect the other end of the USB cable to a USB port on your computer.
Switch on DIGICADRE.
After a few seconds, the message "New device detected" appears on the computer
screen. Wait a few moments until the installation has completed. As soon as the message
"your hardware has been installed and is ready for use" appears, double click on the "My
computer" icon: 6 new removable hard-disks can be seen (fig.26).
Fig.26
Non binding document, subject to modification in the event
of misprint(s) – MKG0207
39
Advertisement
Table of Contents
