HP ProLiant ML10 Specification page 3

QuickSpecs
Standard Features
Expansion Slots
HP Server ROM
Storage Controller
Expansion Technology
Slot #
1
2
3
4
** Slots are enumerated differently based on OS. MS OS's enumerate from lowest to highest Device ID by
bus (starting with the lowest bus).
*** Indicates the number of physical electrical lanes running to a PCI-e connector.
HP ROM (Read Only Memory) is now digitally signed using HP's Corporate Signing Service. This signature is
verified before the flash process starts, reducing accidental programming and preventing malicious efforts
to corrupt system ROM.
HP ROM provides for essential initialization and validation of hardware components before control is
passed to the customer-installed operating system. The ROM also provides the capability of booting from
various fixed media (HDD, CD-ROM) and removable media (USB), to continue operation to the operating
system.
HP ROM performs very early configuration of the video controller, to allow monitoring of initialization
progress via an attached monitor. If configuration or hardware errors are discovered during this early
phase of hardware initialization, suitable messages are now displayed on the connected monitor.
Additionally, these configuration or hardware errors are logged to the Integrated Management Log (IML) to
assist in diagnosis.
HP's ProLiant ROM is used to configure the following:
Processor and chipset status registers
System memory, memory map, and memory initialization
System hardware configuration (Integrated PCI devices and optional PCIe cards).
Customer-specific BIOS configuration (using the HP ROM-Based Setup Utility (RBSU).
NOTE: For further information, please refer to HP's RBSU (ROM based setup utility) user guide:
www.hp.com/support/rbsu.
HP Embedded Smart Array B110i SATA RAID Controller (RAID 0/1/10)
NOTE: Supports up to two (2) 3.0Gb/s SATA hard disk drives only
NOTE: For set up instructions, please refer to the HP ProLiant ML100 series server user guide at:
http://bizsupport1.austin.hp.com/bc/docs/support/SupportManual/c01708878/c01708878.pdf
NOTE: For general information about HP Smart Array B110i SATA RAID Controller, please go to:
http://h18004.www1.hp.com/products/servers/proliantstorage/arraycontrollers/smartarrayb110i/
index.html
DA - 14605 Worldwide — Version 6 — October 25, 2013
Bus
Width***
PCIe G2 x16
PCIe G2 X4
PCIe G2 X4
PCIe G2 X1
HP ProLiant ML10 Server
Connector Width Form Factor
x16 Full height & Half-
length slot
X8 Full height & Half-
length slot
X8 Full height & Half-
length slot
X4 Full height & Half-
length slot
Page 3