Before Operation
SECURITY
•
Before operation, check if the voltage of the unit is in line with the local voltage.
•
Hold the plug to disconnect it from the mains outlet. Do not pull the power cord.
•
When the plug of the unit is connected to the mains outlet, the unit will be still
connected to AC even if the power is turned off.
•
Disconnect the plug as soon as liquid or objects enter the unit. The unit can not
be used until being checked by experts.
•
Do not open the cabinet as laser rays employed by the unit may damage eyes.
Any servicing should be done by qualified service personnel.
PLACEMENT
•
Put the unit where ventilation is good enough to prevent overheating.
•
Never put the unit in direct sunlight or near heat sources.
•
Put the unit in horizontally, never put any heavy object on the unit.
•
To protect the pickup, do not put the unit where there is dust. If there
is dust on the pickup, use a cleaning disc to clean it. Paying particular
attention to the operating instructions of the cleaning disc.
CONDENSATION
Moisture will appear on the pickup lens in the following cases:
•
The unit is suddenly moved from a cold place to a warm place.
•
The unit is put in a room with a heater, or in cold air from an-conditioner.
•
The unit is suddenly moved from a cold place to a warm place.
•
Using the unit in a humid place. In these cases, the unit can not work.
Unload the disc and leave the unit on for about one hour to evaporate
the moisture.
CLEANING
•
Use a soft cloth with a little neutral detergent to wipe the cabinet, panel and
controls.
Never use abrasive paper, polishing powder, solvent like alcohol or gasoline.
HANDLING DISC
•
To keep the disc clean, do not touch the playsides of the disc.
•
Do not attach paper or tape to the disc.
•
Keep the disc away from direct sunlight or heat sources.
•
Store the disc in a disc case after playback.
CLEANING DISC
•
Before playback, wipe the disc outward from the centre with clean cloth.
•
Do not use any type of solvent such as thinner, benzine, commercially
available cleaners or antistatic spray.