Table of Contents
Advertisement
Replacing the Lamp unit
J
Attention
When the projector is mounted on a ceiling, do not work with your face close to the projector.
z
Attach the lamp unit and the lamp cover securely.
z
When you experience difficulty in installing the lamp, remove it and try again. If you use force to install the lamp, the
z
connector may be damaged.
Lamp unit screws
1 )
Turn off the Power by following the procedure in "Powering off the projector".
(
page 28). Remove the power plug from the power outlet. Wait at least 1 hour and
Æ
make sure the lamp unit and surroundings are cool.
2 )
Use a Phillips screwdriver to loosen the two lamp cover screws until the screws turn
freely and open the lamp cover.
3 )
Use a Phillips screwdriver to loosen the two lamp unit screws until the screws turn
freely. Pull up the lamp bar, and pull out the lamp unit gently.
4 )
Insert the new lamp unit in correct direction. Tighten the two lamp unit screws
securely with a Phillips screwdriver.
5 )
Close the lamp cover, and tighten the two Lamp cover screws securely with a Phillips
screwdriver.
Reset the Lamp Hours Used
J
After replacing the lamp unit, make sure to reset the usage time in the [Clear Lamp Hours] menu. (
Maintenance/replacement
Lamp cover screws
Lamp bar
Æ
page 43)
47
ENGLISH -
Advertisement
Table of Contents
