Figure 37 Identify Device Information - Hitachi HTS541616J9SA00 Specifications

85 74xxH
Note.1 The '*' mark in 'Content' field indicates the use of those parameters that are vendor specific.
Note.2 The feature marked '**' is able to be unsupported by the Device Configuration Overlay
command.
Figure 37 Identify device information --- Continued ---
86 3xxxH
Travelstar 5K160 (SATA) Hard Disk Drive Specification
14 (=1) Always
13 (=0) 1=IDLE IMMEDIATE with UNLOAD FEATURE
12- 11 (=0) Reserved
10 (=0) 1=URG bit supported for WRITE STREAM DMA
9 (=0) 1=URG bit supported for READ STREAM DMA
8 (=1) 1=64-bit World wide name supported
7 (=0) 1=WRITE DMA QUEUED FUA EXT command
6 (=1) 1=WRITE DMA FUA EXT and WRITE MULTIPLE
5 (=1) 1=General Purpose Logging feature set supported
4- 2 (=0) Reserved
**1 (=1) 1=SMART self-test supported
**0 (=1) 1=SMART error logging supported
Command set/feature enabled
15 (=0) Obsolete
14 (=1) 1=NOP command supported
13 (=1) 1=READ BUFFER command supported
12 (=1) 1=WRITE BUFFER command supported
11 (=0) Reserved
**10 (=1) 1=Host Protected Area Feature Set supported
9 (=0) 1=DEVICE RESET command supported
8 (=0) 1=SERVICE interrupt enabled
7 (=0) 1=release interrupt enabled
6 (=x) 1=look-ahead enabled
5 (=x) 1=write cache enabled
4 (=0) 1=supports PACKET Command Feature Set
3 (=1) 1=supports Power Management Feature Set
2 (=0) 1=supports Removable Media Feature Set
1 (=x) 1=Security Feature Set enabled
0 (=x) 1=S.M.A.R.T Feature Set enabled
Command set/feature enabled
* 15- 14 (=0) Reserved
13 (=1) 1=FLUSH CACHE EXT command supported
12 (=1) 1= FLUSH CACHE command supported
11 (=x) 1=Device Configuration Overlay supported
* 10 (=1) 1= 48-bit Address feature set supported
9 (=x) 1=Automatic Acoustic Management enabled
8 (=x) 1=SET MAX security extension enabled
7 (=0) Reserved
6 (=1) 1=SET FEATURES subcommand required to spin-up
5 (=x) 1=Power-Up In Standby feature set has been enabled
4 (=0) 1=Removable Media Status Notification Feature Set
supported
EXT and WRITE STREAM EXT
EXT and READ STREAM EXT
supported
FUA EXT commands supported
via the SET FEATURES command
87/167