Security Erase Unit (F4H) - Hitachi HTS541616J9SA00 Specifications

14.29

Security Erase Unit (F4h)

Command Block Output Registers
Register
Data
Feature
Sector Count
LBA Low
LBA Mid
LBA High
Device
Command
Error Register
7 6 5 4
CRC UNC 0 IDN
0 0 0 V
Figure 66 Security Erase Unit Command (F4h)
The Security Erase Unit command initializes all user data sectors, then disables the device lock
function.
Note that the Security Erase Unit command initializes from LBA 0 to Native Max LBA. Host Max
LBA set by Initialize Drive Parameter or Set Max Address command is ignored. So the protected
area by Set Max Address command is also initialized.
This command requests to transfer a single sector data from the host including information specified
in "Erase Unit Information" on
If the password does not match then the device rejects the command with an Aborted error.
Word Description
00 Control word
bit 0
bit 1-15
01-16 Password
17-255 Reserved
Figure 67 Erase Unit Information
Identifier Zero indicates that the device should check the supplied password against the user password
stored internally. One indicates that the device should check the given password against the
master password stored internally.
The Security Erase Unit command erases all user data and disables the security mode feature (device lock function).
So after completing this command, all user data will be initialized to zero with write operation. At this time, it is not
verified with read operation whether the sector of data is initialized correctly. Also, the defective sector information
and the reassigned sector information for the device are not updated. The security erase prepare command should be
completed immediately prior to the Security Erase Unit command. If the device receives a Security Erase Unit
command without a prior Security Erase Prepare command the device aborts the security erase unit command.
This command disables the security mode feature (device lock function), however the master
password is still stored internally within the device and may be re-activated later when a new user
Travelstar 5K160 (SATA) Hard Disk Drive Specification
7 6 5 4 3 2 1 0
- - - - - - - -
- - - - - - - -
- - - - - - - -
- - - - - - - -
- - - - - - - -
- - - - - - - -
- - - - - - - -
1 1 1 1 0 1 0 0
3 2 1 0
0 ABT T0N AM
N
0 V 0 0
Page 5.
: Identifier (1-Mater, 0-User)
: Reserved
(32 bytes)
117/167
Command Block Input Registers
Register
Data
Error
Sector Count
LBA Low
LBA Mid
LBA High
Device
Status
Status Register
7 6 5 4
BSY RDY DF DSC DRQ COR IDX ERR
0 V 0 V
7 6 5 4 3 2 1 0
- - - - - - - -
...See Below...
- - - - - - - -
- - - - - - - -
- - - - - - - -
- - - - - - - -
- - - - - - - -
...See Below...
3 2 1 0
- 0 0 V