Driving Your Focus St; Transmission Operation - Ford Focus ST Supplement Manual

Driving Your Focus ST

MANUAL 6-SPEED TRANSMISSION OPERATION
Using the Clutch
Note: During each shift, the clutch pedal must be fully pressed to the
floor and the accelerator fully released. Failure to follow this may cause
increased shift efforts, prematurely wear transmission components, or
cause gear clash or damage to the transmission. Make sure the floor mat
is properly positioned so it doesn't interfere with the full extension of the
clutch pedal.
Note: If you attempt to shift when the drive wheels are spinning with a
loss of traction, it is possible to cause damage to the transmission. Do
not attempt to shift when the drive wheels do not have traction.
Note: Do not drive with your foot resting on the clutch pedal or use the
clutch pedal to hold your vehicle at a standstill while waiting on a hill.
These actions will reduce the life of the clutch.
Your vehicle is equipped with a twin disc clutch. Due to the high
performance of the powertrain, a certain amount of noise from the
transmission is normal.
The manual transmission has a starter interlock that prevents cranking
the engine unless the clutch pedal is fully pressed.
To start the vehicle:
1. Make sure the parking brake is fully set.
2. Press the clutch pedal to the floor, then put the transmission selector
lever in position N.
3. Start the engine, then press the brake pedal and release the parking
brake.
10
2013 Focus ST (stf)
Supplement, 1st Printing
USA (fus)