GE PP912KMCC Dimensions And Installation Information

PP912TM/KM/BM
GE Profile 30" Built-In CleanDesign Electric Cooktop
™
Dimensions and Installation Information (in inches)
Note: Check local codes for required breaker size
†
KW Rating
Important: Requires a 5" free area between the
240V 7.6
bottom of the cooktop to any combustible material,
208V 5.7
i.e., shelving. Free area not required when installing
Breaker Size
wall oven underneath cooktop. Refer to installation
instructions. Requires a 15" minimum from cooktop to
240V 40 Amps
†
adjacent overhead cabinets. Units are furnished with a
208V
30 Amps
†
48" flexible armored cable.
Note: 30" Ribbon cooktops are approved for use over select GE 27" and GE 30"
Single Wall Ovens and Warming Drawers. Refer to cooktop and wall oven/
warming drawer installation instructions packed with product for current
dimensional data. If installed with a GE Profile
consult both the cooktop and downdraft installation instructions packed with
product before installing. Cooktop gas/electric supply may need to be re-routed
to install downdraft. Consult cabinet and countertop manufacturer's specs for
flush mount installation prior to install. Before installing, consult installation
instructions packed with product for current dimensional data.
Filler Trim Kit: When replacing an old GE 30" cooktop (with larger opening)
use the following one-piece trim kit to fill in the over-size hole. Available at
additional cost. JXTR32W (True White) JXTR32B (Black glass) JXTR32C (True
Bisque)
For answers to your Monogram, ®
GE appliance questions, visit our website at
®
ge.com or call GE Answer Center
800.626.2000.
Telescopic Downdraft System,
™
GE Profile ™ or
service,
®
21-3/8
29-3/4
Cooktop
19-5/8
28-1/2
2-1/2**
Required
* Depth of unit at conduit connection location (rear) is
6-1/2" on models PP980/975/950/945 and 4-5/8"
on models PHP900/PP972/962/942/932/912,
JP655/356/346.
**Raised bull nose countertops may require up to
3/8" additional clearance to prevent interference
with curved front.
30_color_cktp_install.eps
13" MAX.
depth
3-1/4*
30" MIN. to
unprotected
cabinet
15" MIN.
to cabinet
1-3/4" to
rear wall
1-1/2" MIN.
clearance to
side wall
from cut-out
Electrical junction box 16" MIN.
below countertop
Specification Revised 12/07
1-1/2" MIN.
clearance to
side wall
from cut-out
Cut should
not interfere
with cabinet
structure
at front
Listed by
Underwriters
Laboratories
220581