Setting Cruise Control; Resuming A Set Speed - Cadillac 2014 SRX Owner's Manual

9-34 Driving and Operating
®
If the StabiliTrak system begins to
limit wheel spin while using cruise
control, the cruise control
automatically disengages. See
. If a collision
alert occurs when cruise control is
activated, cruise control is
disengaged. See
When road conditions allow the
cruise control to be safely used, you
can apply the cruise control again.
(On/Off): Press to turn the
system on and off. A white cruise
control indicator appears in the
instrument cluster when cruise is
turned on.
+RES (Resume/Accelerate):
Press the control up briefly to make
the vehicle resume to a previously
set speed, or press and hold to
.
accelerate. If cruise control is
already active, use to increase
vehicle speed.
SET (Set/Coast): Press the
control down briefly to set the speed
and activate cruise control. If cruise
control is already active, use to
decrease vehicle speed.
(Cancel): Press to disengage
cruise control without erasing the
set speed from memory.

Setting Cruise Control

If the cruise button is on when not in
use, it could get pressed and go into
cruise when not desired. Keep the
cruise control button off when cruise
is not being used.
1. Press to turn the cruise
system on.
2. Get up to the desired speed.
3. Move the control down to SET
and release it.
4. Remove foot from the
accelerator.
When the cruise control has been
set to the desired speed, the green
cruise control indicator appears on
the instrument cluster.

Resuming a Set Speed

If the cruise control is set at a
desired speed and then the brakes
are applied, the cruise control is
disengaged without erasing the set
speed from memory.
Once the vehicle speed reaches
about 40 km/h (25 mph) or more,
move the control up toward +RES
briefly. The vehicle returns to the
previous set speed.