Troubleshooting Tips - GE Monogram 164D3333P095 Use And Care Manual

Trouble-
shooting tips
36
PROBLEM
UNABLE TO GET
THE DISPLAY TO
SHOW "SF"
"PROBE" APPEARS
IN THE DISPLAY
POWER OUTAGE,
CLOCK FLASHES
STEAM FROM
THE VENT
"BURNING" OR
"OILY" ODOR
EMITTING FROM
THE VENT
STRONG ODOR
FAN NOISE
POSSIBLE CAUSE
• Oven control pads were not pressed properly. The BAKE and the
BROIL HI/LO pads (on double oven models use the upper oven
controls) must be pressed at the same time and held for 3 seconds.
• This is reminding you to enter a probe temperature after plugging
in the probe. Enter a probe temperature.
• Power outage or surge. Reset the the clock. If the oven was in use,
you must reset it by pressing the CLEAR/OFF pad, setting the clock
and resetting any cooking function.
• When using the convection feature, it is normal to see steam coming
out of the oven vent. As the number of shelves or amount of food
being cooked increases, the amount of visible steam will increase.
• This is normal in a new oven and will disappear in time. To speed
the process, set a self-clean cycle for a minimum of 3 hours. See the
Using the Self-Cleaning Oven section.
• This is temporary. An odor from the insulation around the inside of
the oven is normal for the first few times the oven is used.
• A cooling fan or a convection fan (depending on the function you
are using) may automatically turn on and off to cool internal parts.
This is normal. The cooling fan will turn off and on. The convection
fan will run until the function is over or the door is opened.
Before You Call For Service...
Wall Oven