Weslo Cadence C32 Treadmill User Manual page 6

3. With the help of a second person, lift the Frame (79) and
attach the Base (46) to the Right Upright (62) with two
Upright Bolts (65), two 3/8" Washers (66), and two 3/8"
Nuts (61) as shown.
Attach the Base (46) to the Left Upright (not shown) in
the same way.
Attach the Wheels (68) to the outside of the Base with
two Wheel Bolts (67), 3/8" Washers (66), and 3/8" Nuts
(61) (only right side shown). Do not overtighten the
Wheel Bolts.
4. Raise the treadmill to the upright position.
If there are plastic ties in the brackets on the Handrails
(59), remove them. Hold a Handrail near the Right
Upright (62). Insert the Wire Harness (60) up through the
bracket on the Handrail and out of the round hole in the
center of the Handrail. If necessary, use needlenose pli-
ers to pull the Wire Harness out of the hole. Be careful
not to damage the Wire Harness. Insert the brackets
into the tops of the Left and Right Uprights (53, 62).
Hand tighten four Handrail Bolts (42) with 1/4" Washers
(38) into the Uprights (53, 62) and the Handrails (59).
Remove the tape from the connectors at the end of the
Wire Harness (60).
5. Set the Console Base (52) on the Handrails (45, 59).
Thread four 3/4" Screws (2) into the Handrails and the
Console Base. After you have started all four Screws,
tighten the Screws until they are snug; do not over-
tighten the Screws.
Firmly tighten but do not overtighten the bolts used
in steps 2 through 4.
6. Insert the Battery Cover (54) up through the bottom of
the Console Base (52), with the hinges in the position
shown. The Cover should pivot down, away from the
Console Base.
3
62
61
79
4
59
38
42
5
59
2
6
6
65
61
66
66
46
67
68
Connectors
60
42
38
59
Bracket
53
38
42
38
52
2
52
Hinges
54
42
62
45