Uto Alk; Registration; Auto Talk - GE 28213 Series User Manual

Auto Talk

When this function is ON, during an external call, you may lift the handset to answer a
call immediately without pressing any buttons. To end a call, put the handset back on
the base cradle directly.
From the Initial Setup Menu:
Press the caller ID-volume (5 or 6) button to scroll to the AUTO TALK sub-menu.
1.
Press mute/menu OK button to enter the menu. The screen displays > NO YES.
.
Use the caller ID-volume (5 or 6) button to scroll to your selection. NO is the
.
default setting.
Press the mute/menu OK button to confirm.
.

Registration

Your packaged handset(s) are pre-registered and ready to use. It is not recommended
that a handset be registered again unless absolutely necessary.
From the Initial Setup Menu:
Press the caller ID-volume (5 or 6) button to scroll to the REGISTRATION
1.
sub-menu.
Press the mute/menu OK button to enter the menu. The screen displays YES4NO.
.
The default setting is NO.
Use the caller ID-volume (5 or 6) button to scroll to YES or NO.
.
If you select YES, press the mute/menu OK button. The screen displays HOLD
.
BASE FIND FOR 5 SECONDS, THEN PRESS MENU OK KEY. (Your handset should be
held near the base during registration process.)
Press and hold the find button on the base unit, the charge/in use indicator
5.
flashes. Press the handset mute/menu OK button. The screen displays
REGISTERING. The handset screen displays REGISTERED. You may now rename
your handset. (Refer to Step & of Handset Name Section)
NOTE: If you are re-registering the handset through the handset
menu; to rename your handset you must go to the Handset Name
Section and start from the beginning step.
18