Do you have a question about the Cadence 835 and is the answer not in the manual?
Questions and answers
Jonathan Graniero
April 18, 2025
Re: cadence 835 My 25 + yr weslo treadmill belt stopped after 3 minutes suddenly today. Top electrical board works. No power to deck/belt/incline don’t work. Any ideas on how to fix ?
1 comments:
Mr. Anderson
May 10, 2025
If a Weslo Cadence 835 treadmill stops after 3 minutes and has no power to the deck, belt, or incline, follow these troubleshooting steps:
1. Check Power Supply: - Ensure the treadmill is plugged into a working outlet. - Test the outlet with another device to confirm it provides power. - Verify the power cord is securely connected.
2. Inspect Safety Key: - Make sure the safety key is properly inserted. The treadmill won’t run without it.
3. Reset the Circuit Breaker: - Locate the reset switch (usually near the power cord). - If it has tripped, wait a few minutes and press it to reset.
4. Motor Control Board: - Unplug the treadmill and remove the motor hood. - Check for burned components or loose wires on the motor control board. - Look for LED indicator lights—no light may mean board failure.
5. Check Motor and Belt: - Inspect the drive motor and walking belt for signs of wear or damage. - Try to manually move the belt; resistance may indicate a jam.
6. Test Incline Motor: - Press incline up/down buttons and listen for motor sounds. - No sound may indicate a faulty incline motor or control board.
7. Inspect Internal Wiring: - Look for loose, disconnected, or damaged wires, especially between the console, motor, and control board.
8. Thermal Overload: - Let the treadmill cool for 15–30 minutes. Continuous running can trigger thermal protection.
If the issue persists after these steps, the motor control board or motor may need replacement.
Need help?
Do you have a question about the Cadence 835 and is the answer not in the manual?
Questions and answers
Re: cadence 835 My 25 + yr weslo treadmill belt stopped after 3 minutes suddenly today. Top electrical board works. No power to deck/belt/incline don’t work. Any ideas on how to fix ?
If a Weslo Cadence 835 treadmill stops after 3 minutes and has no power to the deck, belt, or incline, follow these troubleshooting steps:
1. Check Power Supply:
- Ensure the treadmill is plugged into a working outlet.
- Test the outlet with another device to confirm it provides power.
- Verify the power cord is securely connected.
2. Inspect Safety Key:
- Make sure the safety key is properly inserted. The treadmill won’t run without it.
3. Reset the Circuit Breaker:
- Locate the reset switch (usually near the power cord).
- If it has tripped, wait a few minutes and press it to reset.
4. Motor Control Board:
- Unplug the treadmill and remove the motor hood.
- Check for burned components or loose wires on the motor control board.
- Look for LED indicator lights—no light may mean board failure.
5. Check Motor and Belt:
- Inspect the drive motor and walking belt for signs of wear or damage.
- Try to manually move the belt; resistance may indicate a jam.
6. Test Incline Motor:
- Press incline up/down buttons and listen for motor sounds.
- No sound may indicate a faulty incline motor or control board.
7. Inspect Internal Wiring:
- Look for loose, disconnected, or damaged wires, especially between the console, motor, and control board.
8. Thermal Overload:
- Let the treadmill cool for 15–30 minutes. Continuous running can trigger thermal protection.
If the issue persists after these steps, the motor control board or motor may need replacement.
This answer is automatically generated