Weslo Cadence 30.8 Treadmill User Manual page 6

3. Refer to the inset drawing. If there is a plastic tie holding
the Cage Nut (104) in the Right Handrail (1), remove the
plastic tie. Pull 10 to 12 cm (4 to 5 in.) of the Wire
Harness (21) out of the Right Upright (11). Feed the Wire
Harness up through the bracket on the Right Handrail
and out of the indicated hole. If necessary, use
needlenose pliers to grip and pull the out of the holes Wire
Harness.
Insert the bracket on the Right Handrail (1) into the upper
end of the right Upright (11). Hand tighten two Handrail
Bolts (105) with Washers (39) into the Upright as shown.
Attach the Left Handrail (41) to the left Upright (11) as
described above. Note: There is no wire in the left Upright.
4. Place the Console Base (46) on the Right and Left
Handrails (1, 41). Make a loop with the indicated plastic
tie and insert the two Wires (21) through the loop. Pull out
just enough of the Wires to connect the Wires to the two
connectors in the Console Base. Important: Insert the
two Wires fully into the connectors. Then, tighten the
loop and cut off the excess plastic tie. WARNING: Never
disconnect or connect the Wires while the treadmill
power cord is plugged in.
Refer to drawing 4b. Thread four Screws (99) into the
Left and Right Handrails (1, 41) and the Console Base
(46). After all four Screws have been started, tighten the
Screws until they are snug; do not overtighten the
Screws.
Refer to step 3. Tighten the four Handrail Bolts (105).
5. Attach the Storage Latch (14) to the left Upright (11) with
the two Latch Screws (99). Be careful not to over-
tighten the Latch Screws.
6. Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen
wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 13). To protect the
floor, place a mat under the treadmill.
3
41
39
105
1
21
104
Tie
11
4a
1
Tie
4b
1
5
14
6
21
105
39
39
1
11
11
39
105
34
21
46
99
11
99
105
46
41
99