Canon MG5200 series Manual page 407

Advanced Guide > Printing Using the Operation Panel of the Machine
Side of Disc
D003
Copying the Label Side of Disc
Copy the label of an existing BD/DVD/CD and print it on a printable disc.
Important
You cannot print on 3.15 inches / 8 cm printable discs.
Do not attach the Disc Tray until the message asking you to set the printable disc is displayed.
Doing so can damage the machine.
Note
If printing is misaligned, adjust the printing position. For information on how to adjust it, see
Adjusting the Print Area
1.
Display the Copy menu screen.
How to Select a Useful Copy Menu
2.
Select Disc label, then use the OK button to confirm the selection.
The print area setting screen is displayed.
3.
Use the button to select Outer circle or Inner circle and use the
change the print area.
4. Use the button to confirm the selection.
OK
Note
Measure the outer and inner diameters of the printing surface of the printable disc and make
sure you set a value smaller than the measured value for the outer diameter, and a value larger
than the measured value for the inner diameter.
For information on printable discs, contact their manufacturers.
5. Use the button to select Recommended disc or Other disc, then use the
button to confirm the selection.
Note
If your printable disc is the recommended disc, specify Recommended disc for the suitable
density printing. If not, specify Other disc.
6.
Load the copy source BD/DVD/CD on the Platen Glass, then use the
go to the next step.
The disc label standby screen is displayed.
Important
Be sure to load the copy source BD/DVD/CD with its label side down on the center of the Platen
Glass. If you load it near the edge of the Platen Glass, part of the image may be cut off.
7.
Use the Color button for color copying, or the Black button for black & white
.
> > Copying the Label
Using Useful Copy Functions
OK
button to
OK
button to