Schwinn 520 Reclined Elliptical Assembly Manual page 29

Condition/Problem
Console shuts off (enters
sleep mode) while in use
Unit rocks/does not sit
level
Foot pedals loose/unit dif-
ficult to operate
Clicking sound when
operating
Things to Check
Check data cable integrity
Check data cable
connections/orientation
Reset machine
Check the position of
Speed Sensor Magnet
(requires shroud removal)
Check Speed Sensor
Check leveler adjustment
Check surface under unit
Hardware
Check pedal leg to crank
arm connection
All wires in the cable should be intact. If any are cut or crimped,
replace cable.
Be sure cable is connected securely and oriented properly.
Small latch on connector should line up and snap into place.
Remove batteries from unit for 3 minutes. Reinstall batteries
and start Console.
Speed Sensor Magnet should be in place on pulley.
Contact Customer Care for further assistance.
Adjust levelers until machine is level.
Adjustment may not be able to compensate for extremely un-
even surfaces. Move machine to level area.
Tightly secure all hardware on the Pedal Legs.
Remove pedal legs and reattach.
Solution
29