PART IDENTIFICATION CHART
Use the drawings below to identify the small parts needed for assembly. The number in parentheses below each
drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the
key number is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if it
has been preassembled. Extra parts may be included.
M5 Washer
M8 Washer
M10 Split
16mm Wave
(94)–2
Washer (105)–8
Washer (54)–2
(97)–8
M8 Locknut
M4 x 16mm
M8 x 38mm
M8 x 13mm
(102)–4
Screw (101)–16
Screw (82)–8
Bolt (96)–4
M10 x 25mm
M10 x 122mm
Screw (99)–4
Screw (104)–4
7