Cleaning The Door; Error Code Failure System - Baumatic BDI631 Insrtuction Manual

Cleaning the door

o To clean the edge around the outside of the door, you should use
a soft, damp cloth only.
o To prevent water from penetrating the door lock or electrical
components, DO NOT use a spray cleaner of any kind.
o DO NOT use any abrasive cleaner or scouring pads on the inner
or outer surfaces, as they may cause damage to them.

Error code failure system

If your appliance senses that it is not operating correctly, then a
combination of the program indicator neons may flash.
The following error codes can possibly be remedied by the customer
and the steps outlined below should be followed.
BEFORE COMPLETING
APPLIANCE, IT SHOULD BE DISCONNECTED FROM YOUR MAINS
POWER SUPPLY.
Intense wash indicator neon flashes
o Longer than expected fill time.
Check the water pressure of your mains water supply.
Clean the mesh filter that sits in the inlet hose.
Ensure that the inlet hose is not kinked or crushed.
Make sure the water tap that the machine is connected to is turned
on fully.
Economy wash indicator neon flashes
o Longer or extended drain time.
The drain pipe may be placed in too high a position or incorrectly.
Check the installation instructions and ensure that the installation is
correct.
Check that the outlet hose is not kinked or crushed.
Make sure that the drain hose has not been extended beyond its
original length.
ANY MAINTAINEANCE ON THE
25