Power Supply
2
Installation
CAUTION!
Installation should only be performed by qualified service
personnel in accordance with the National Electrical Code or
applicable local codes.
Disconnect the supply power before installing
2.1
Tools required
–
–
–
2.2
Opening the side covers
Figure 2.1 Removing side covers
Unscrew the four cross-head screws at each corner and remove
each of the side covers.
2.3
Mount the unit
Figure 2.2 Mounting the unit
Secure the unit to a flat surface using mounting screws (not
supplied) in the four holes (4 mm) shown in the figure.
Bosch Security Systems
Small flat blade screwdriver.
Crosshead screwdriver.
Wire cutter/stripper tool.
Installation manual
Installation | en
AR18-10-B002 | v1.1 | 2010.02
13