Before You Call For Service - GE 234D1157P003 Owner's Manual

Profile dryers
Table of Contents

Advertisement

Available languages

Available languages

before you call for service...

Problem
Clothes take too long
to dry
Clothes are wrinkled
Clothes shrink
Water seen on inside of
door and top of lint filter
when opening door after
steam cycle
Small areas on clothes are Steam condenses on inner drum
damp after steam cycle
Possible Causes
Improper sorting
Large loads of heavy fabrics
(like beach towels)
Controls improperly set
Lint filter is full
Improper or obstructed
ducting
Blown fuses or tripped
circuit breaker
Overloading/combining loads
Underloading
Overdrying
Letting items sit in dryer
after cycle ends
Overloading
Some fabrics will naturally shrink • To avoid shrinkage, follow garment care labels exactly.
when washed. Others can be
safely washed, but will shrink
in the dryer
Steam condenses on these
surfaces
What To Do
• Separate heavy items from lightweight items (generally,
a well-sorted washer load is a well-sorted dryer load).
• Large, heavy fabrics contain more moisture and take
longer to dry. Separate large, heavy fabrics into smaller
loads to speed drying time.
• Match control settings to the load you are drying.
• Clean lint filter before every load.
• Check installation instructions for proper
ducting/venting.
• Make sure ducting is clean, free of kinks and
unobstructed.
• Check to see if outside wall damper operates easily.
• Check the Installation Instructions to make sure the
dryer venting is correct.
• Replace fuses or reset circuit breakers. Since most dryers
use 2 fuses/breakers, make sure both are operating.
• Do not put more than one washer load in the dryer at
a time.
• If you are drying only one or two items, add a few items
to ensure proper tumbling.
• Select a shorter drying time.
• Remove items while they still hold a slight amount of
moisture. Select a lESS DRy or DAMP DRy setting.
• Remove items when cycle ends and fold or hang
immediately.
• Separate large loads into smaller ones.
• Some items may be pressed back into shape after drying.
• If you are concerned about shrinkage in a particular
item, do not machine wash or tumble dry it
• This is normal.
• If using the STEAM DEWRInklE cycle, manually reduce
the cycle time. If using the STEAM REfRESh cycle, add
more garments to the load.
GEAppliances.com
13

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents