IP Camera 200 Series
3.4
Power connection
The camera can accept power from both the DC12V power
input and the Ethernet input at the same time. You can remove
either one of the power sources without interrupting camera
operation.
3.4.1
DC power connection
Figure 3.2 DC power connection
Connect power from a 12 VDC class 2 power supply as follows:
1.
2.
3.
4.
Bosch Security Systems
12 VDC
Use AWG22 wire; cut back 5 mm (0.2 in) of insulation.
Remove the 2-pole connector from the camera cable tree.
Loosen the screws and insert the wires.
Tighten the screws and reconnect the 2-pole connector to
the power connector of the camera cable tree.
Installation Manual
5 mm
(0.2 in)
22AWG
Installation | en
AM18-Q0616 | v1 | 2012.02
15