3Dlabs Oxygen GVX1 Pro User Manual page 10

4. Remove the cover from your system so you can access the slot(s) into which you
will be installing your 3Dlabs Graphics Accelerator Card. If you have not
already removed any existing graphics card from your system, then do so now.
5. If necessary, remove the back panel cover(s) from the slot(s) into which you are
going to install your 3Dlabs Graphics Accelerator Card, using the Phillips-head
screwdriver you should have handy.
6. If an anti-static wrist strap was included in your box, attach it to your wrist and
attach the other end to a bare metal (as opposed to painted or sticker covered)
surface on your system's chassis.
7. Remove your new 3Dlabs Graphics Accelerator Card from its anti-static
packaging. Write down the serial number for product registration and future
use. The serial number is located on a board label and looks like this:
4
136001B123456 Made in XXX Week XXXX
3Dlabs Graphics Accelerator Card User's Manual
Installation