Advertisement
SonicFury Installation Guide
Installing SonicFury
Before you continue
If you have on-board audio, you must disable it before installing SonicFury. This is usually
done through the BIOS control, which you can access while your computer is booting up
(starting). To do this, refer to your computer's documentation.
If you have another sound card in your computer, you should also remove its drivers to prevent
any conflicts before installing SonicFury. To do this, refer to the card's documentation.
Installing the hardware
Warning: Always switch off your computer before removing the cover and observe the warnings
specified in the manufacturer's documentation.
1. Switch off your computer, monitor, and any hardware devices connected to your computer.
2. Switch off the plug at the socket, but leave the power cable connected to ensure grounding.
3. Remove the computer's cover.
4. Locate a spare PCI slot and remove the back plate cover. Keep the screw, you will need it.
5. Touch the computer's bare metal chassis with the back of your hand to discharge any static.
6. If you already have a sound card in your computer, remove it now.
7. If you want to connect SonicFury's internal sockets, do so now (see the diagram opposite):
CD and aux in accept sound from your CD or video player, or auxiliary line source.
TAD in/out enables you to use your PC as a telephone. To do this, connect TAD to your
internal modem, a microphone to mic, and headphones or loudspeakers to front or rear.
wavetable header connects to a MIDI wavetable upgrade, such as the Roland Sound
Canvas.
CD Digital in connects to the digital output on the latest CD drives.
- 4 -
Advertisement
