Installation - Alpine INE-S900R Quick Reference Manual

Installation

When making connections to the vehicle's
•
electrical system, be aware of the factory installed
components (e.g. on-board computer). Do not
tap into these leads to provide power for this
unit. When connecting the INE-S900R to the fuse
box, make sure the fuse for the intended circuit
of the INE-S900R has the appropriate amperage.
Failure to do so may result in damage to the unit
and/or the vehicle. When in doubt, consult your
Alpine dealer.
The main unit must be mounted within 40 degrees
•
of the horizontal plane, back to front.
0 - 40°
1
Check accessory parts.
GPS Antenna Waterproof pad
(5 m) (for GPS
antenna)
×5
Cable clamp Microphone
(for GPS (3.5 m)
antenna)
AUX/PRE OUT External Interface
connector cable connector cable
Face plate Mounting sleeve
Hex bolt Bracket key
×8
Screw
Owner's manual
2
e
Antenna
mounting plate
3
Power cable
USB cable
Rubber cap
×6
×2
Flush head screw
Mount the GPS Antenna on the roof.
Clean dust and oil at the mounting
location and mount the GPS Antenna.
GPS Antenna
Mounting the GPS Antenna inside
the vehicle.
1 Clean the mounting location.
2 Put on the GPS Antenna mounting plate.
3 Mount the GPS Antenna.
Antenna mounting plate
Routing the GPS Antenna cable.
1 Route the cable using the provided cable
clamps to take up the cable's slack.
2 Use the waterproof pad when running the
cable under one of the vehicle's rubber
gaskets.
3 Attach the cable at several points using
the remaining cable clamps.
Waterproof pad
Installation
GPS Antenna
Cable clamp
EN
EN-11