Errata - System Management - ADTRAN NetVanta 7000 Manual

NetVanta 7000 Series Release Notes R10.7.1
• Frequent parking and retrieval of calls caused the switchboard to be unable to find a target for call routing
and caused the unit to reboot.
• When Music-On-Hold was set to external, Polycom IP phones were not able to blind transfer a call.
• ADTRAN/Polycom phones running a 3.3.x version firmware would not load the idle display logo image.
• An incoming call from an ISDN trunk that was parked and then retrieved by an extension logged into a
call queue had no audio.
• The SMTP messages sent for voicemail notification were rejected due to a missing carriage return.

Errata - System Management

The following is a list of System Management errata that still exist in
• The NetVanta 7100 and NetVanta 6355 platforms will fail to reset QoS map statistics for applied QoS
maps when the clear counters command is executed.
• When adding a new user account, the GUI may incorrectly display an FXS port as available when it is
already assigned.
• The CLI command, no description, cannot be used to remove a description from a ring group
configuration.
• If an attempt is made to configure greater than the maximum number of call queues, an error will be
shown. Following this error, no call queue configuration commands can be entered until the configuration
mode is exited.
• When trying to apply a user account change in IE9, a database error is presented. Workaround: Use
Ctrl+F5 to clear the IE browser cache or use an alternate web browser.
• The Startup Wizard does not present an error message if an invalid VLAN ID is entered when configuring
the Data and Voice VLAN tags.
• An HTTP timeout does not output the correct string in the CLI. Instead a %s is substituted.
• If Change Language is selected as the Collect Digits action in an Auto Attendant, no option to set the
desired language appears.
• After upgrading from A4.X or A5.X to R10.2 or later the GUI does not highlight Polycom IP 550/560
phones to indicate the phone configuration requires updated.
• When creating a new user in the GUI, DID numbers and aliases are not saved if the Edit Config button is
pressed followed by the Apply button.
• When using the GUI to configure voicemail notification for a user, the times midnight and noon are
mistakenly swapped.
• Inserting a CompactFlash card into the device while it is powered results in a reboot.
• In the VQM RTP Monitoring menu, the Source IPs and Interfaces menus have invisible data points that
appear and display data when the cursor hovers over them. The invisible data point information duplicates
a visible data point and can usually be found hidden above the visible data point.
• In the VQM RTP Monitoring menu, the refresh button refreshes the displayed graphic, but it also
duplicates information in the lower part of the menu. Also, when the cursor hovers over a data point, it
displays multiple instances of the same data.
• After a pickup group has been created, the pickup extension and description cannot be modified.
Copyright © 2013 ADTRAN, Inc.
Errata - System Management
AOS version R10.7.1
.
9