Table of Contents
Advertisement
v Remove jewelry, such as bracelets, necklaces, rings, and loose-fitting wrist
v Remove items from your shirt pocket, such as pens and pencils, that might fall
v Avoid dropping any metallic objects, such as paper clips, hairpins, and screws,
Handling static-sensitive devices
Attention:
To avoid damage, keep static-sensitive devices in their static-protective packages
until you are ready to install them.
To reduce the possibility of damage from electrostatic discharge, observe the
following precautions:
v Limit your movement. Movement can cause static electricity to build up around
v The use of a grounding system is recommended. For example, wear an
v Handle the device carefully, holding it by its edges or its frame.
v Do not touch solder joints, pins, or exposed circuitry.
v Do not leave the device where others can handle and damage it.
v While the device is still in its static-protective package, touch it to an unpainted
v Remove the device from its package and install it directly into the server without
v Take additional care when you handle devices during cold weather. Heating
Removing the cover
To remove the cover, complete the following steps:
1. Read the safety information that begins on page v and "Installation guidelines"
2. Turn off the server and all attached devices.
3. Disconnect all external cables and power cords.
watches.
into the server as you lean over it.
into the server.
Static electricity can damage the server and other electronic devices.
you.
electrostatic-discharge wrist strap, if one is available. Always use an
electrostatic-discharge wrist strap or other grounding system when you work
inside the server with the power on
metal surface on the outside of the server for at least 2 seconds. This drains
static electricity from the package and from your body.
setting down the device. If it is necessary to set down the device, put it back into
its static-protective package. Do not place the device on the server cover or on a
metal surface.
reduces indoor humidity and increases static electricity.
on page 11.
Chapter 2. Installing optional devices
13
Advertisement
Table of Contents
