Viking 15”W Installation Manual page 7

Gasket
Machine
Screw
Hole Plug
Cover
Use Upper
Hole at the
Top
Accessory
Door Panel
Use Lower
Hole at the
Bottom
attached, it must be removed to access hinge screws.
Note: If the hinges are used to secure the unit to the cabinet, DO NOT use the side covers.
Built In Situations: If a finished floor is to be installed in the area after the ice machine has been built in, shims the expected
thickness of the floor should be installed under the unit to keep the machine level with the planned floor level.
Installations on a slab: Use a pump model and pump the water to the point of drainage. Pump models will pump 1 story
(10 feet) high.
Installations over a crawl space or basement: Either gravity drain or pump model units may be used, if there is not
enough room behind the machine for a drain/waste receptacle, the drain will have to be below the floor.
Note: When installed in a corner, the door swing may be limited due to handle contact with the wall or cabinet face.
Note: If door panel is
Front
screw
Bottom
screw
Inner screw
Outer screw
Screw
Upper
door
bracket
Lower
door
bracket
Insert door
stop pin