GE AJCH 08 Owner's Manual page 20

WINDOW INSTALLATION—OPTIONAL (cont.)
7 INSTALL CASE IN WINDOW
A Peel off the backing from the bottom
window gasket.
B
Place the gasket on the stool and over the
brackets, even with the rear edge, sticky
side down.
Bottom window gasket
C Carefully slide the empty case into the
window until the holes in the case line up
with the holes in the panel angles.
Case holes
OTES:
N
• The case should have a 1/8" minimum tilt
toward the outside.
• Be sure the seal gasket and panel gaskets
remain in position and do not roll with the
case.
D Lower the window so it fits behind the panel
tabs. Insert the 4 type A screws through the
holes in the case and into the panel angles,
2 on each side.
Panel
tabs
Installation Instructions
Case
screws
E
With the window closed, mark where the
window sash meets the case.
F
Peel off the backing from the case top gasket.
G
Hold on to the case, open the window, and
place the gasket along the mark on the case.
Put the gasket
on top of the
case where
the window
will close.
H Place the vinyl window gasket over the case top
gasket. Insert the panel tabs through the slits in
the gasket. Cut the gasket on each side to the
width of the window.
Panel
tab
I
Close the window tightly on the vinyl gasket.
Bend the gasket forward to expose the panel
tabs. Drill pilot holes into the window sash.
20
Vinyl window
gasket
Attach the panel tab
to the window on
each side with a type
D screw.