ProForm 320 Cx Bike Manual page 8

5. Make sure that the Main Wire (89) and the
Frame Pulse Wire (30) are in the location
shown.
Using a small plastic bag to keep your fingers
clean, apply a coat of the included grease to an
M6 x 70mm Bolt Set (67).
Tip: Avoid pinching the wires. Attach the
Handlebar (6) to the Upright (4) with the M6 x
70mm Bolt Set (67) and two M8 Washers (70).
Then, attach an M6 x 60mm Bolt Set (68)
through the lower bracket on the Handlebar
(6). Make sure that the Bolt Set is inside the
bracket.
6. Insert the Main Wire (89) and the Frame Pulse
Wire (30) upward through the indicated hole in
the Handlebar (6).
7. While another person holds the Console (7)
near the Handlebar (6), connect the wires on the
Console to the Main Wire (89) and the Frame
Pulse Wire (30).
Insert the excess wire downward into the Upright
(4) or upward into the Console (7).
Tip: Avoid pinching the wires. Attach the
Console (7) to the Handlebar (6) with four M4 x
16mm Screws (79).
5
67
70
68
6
7
7
Avoid pinching
the wires
8
Avoid pinching
the wires
6
70
Grease
67
30
68
89
4
6
30
89
6 79
30
89
4