ProForm 120 R Bike Manual page 11

14. The Console (4) can use four D batteries (not
included); alkaline batteries are recommended.
Do not use old and new batteries together or
alkaline, standard, and rechargeable batter-
ies together. IMPORTANT: If the Console has
been exposed to cold temperatures, allow
it to warm to room temperature before you
insert batteries. Otherwise, you may dam-
age the console displays or other electronic
components.
Remove the two battery covers from the back
of the Console (4), and insert batteries into the
battery compartments. Make sure to orient the
batteries as shown by the diagrams inside
the battery compartments. Then, reattach the
battery covers.
To purchase an optional power adapter, call
the telephone number on the cover of this
manual. To avoid damaging the console,
use only a manufacturer-supplied power
regulated adapter. Plug one end of the power
adapter into the receptacle inside the battery
compartment on the console; plug the other end
into an outlet installed in accordance with all
local codes and ordinances.
15. While a second person holds the Console (4)
near the Handlebar (13), connect the wire on the
Console to the Wire Harness (53).
Insert the excess wire into the Handlebar (13).
Tip: Avoid pinching the wires. Attach the
Console (4) to the Handlebar (13) with six M4 x
16mm Screws (56); start all of the Screws, and
then tighten them.
14
4
Battery
Cover
15
13
4
Avoid pinching
the wires
11
Battery
Cover
56
56
56
53