Assembly - Image Fitness 4.0 Ex Bike User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included tools and your own adjustable spanner
screwdriver
Use the drawings below to identify the small parts used for assembly. The number in parenthesis below each
drawing is the key number of the part, from the PART LIST on pages 20 and 21. The number following the key
number is the quantity needed for assembly. Note: Some small parts may have been pre-assembled. If a part
is not in the parts bag, check to see if it has been pre-assembled.
M6 Nylon Locknut
(63)–4
M4 x 16mm
Screw (57)–1
M6 x 25mm Button
Screw (99)–1
M8 x 38mm Button Bolt
1. Orient the Front Stabiliser (15) as shown. Whilst
another person lifts the front of the Frame (1), attach
the Front Stabiliser to the Frame with two M8 x 52mm
Button Screws (54) and two M8 Washers (64).
.
M8 Nylon Locknut
(49)–4
M4 x 20mm
Screw (101)–1
M6 x 32mm Button Bolt
(102)–4
(96)–4
M6 Washer M8 Washer
(66)–4
M6 x 16mm Button
Screw (8)–4
M8 x 12mm
Button Screw
(106)–4
M8 x 52mm Button Screw
(54)–2
1
5
and Phillips
M4 x 12mm
Screw (41)–6
(64)–2
M6 x 22mm Button
Screw (93)–3
M8 x 24mm Button
Screw (40)–4
1
15
64
54