Image Fitness 4.0 Ex Bike User Manual page 13

To reset the displays, press the On/Reset button.
Note: The con-
sole can display
speed and dis-
tance in either
miles or kilome-
tres. The letters
MPH or KM/H will appear in the lower section of
the large display to show which unit of measure-
ment is selected. To change the unit of measure-
ment, hold down the On/Reset button for about
six seconds. Note: When the button is held down,
the fan will turn on for a moment. When the bat-
teries are replaced, it may be necessary to rese-
lect the desired system of measurement.
5
Measure your heart rate if desired.
If there are
sheets of clear
plastic on the
metal contacts
on the hand-
grip pulse sen-
sor, peel off
the plastic. To
use the hand-
grip pulse sensor, hold the handgrips with your
palms resting against the metal contacts. Avoid
moving your hands. When your pulse is detect-
ed, the heart-shaped indicator in the large display
will flash each time your heart beats. After a
moment, two dashes (– –) will appear and then
your heart rate will be shown.
EBIE6215
(IMEVEX6215.0)
Metal
Contacts
For the most accurate heart rate reading, contin-
ue to hold the handgrips for about 30 seconds.
Note: When you first hold the handgrips, the
large display will show your heart rate continu-
ously for 30 seconds. The display will then show
your heart rate along with other feedback modes.
6
Turn on the fan if desired.
To turn on the
fan at low speed,
press the fan
button. To turn
on the fan at
high speed,
press the fan
button a second
time. To turn off
the fan, press the fan button a third time. Note: If
the fan is turned on but the pedals are not moved
for thirty seconds, the fan will automatically turn
off to conserve the batteries.
Rotate the thumb wheel on the right side of the
console to pivot the fan to the desired angle.
7
When you are finished exercising, the console
will automatically turn off.
If the pedals are not moved for a few seconds,
the displays will pause and the time will flash in
the large display.
If the pedals are not moved and the console but-
tons are not pressed for a few minutes, the con-
sole will turn off to conserve the batteries.
13
Thumb
Wheel
Fan
Button