GE 10 ACA Owner's Manual page 12

Installing a J-Model in an existing wall case.
Read these instructions completely and carefully.
Install the Air Conditioner in the Case.
Remove the locking plate on the front
A
left side.
Locking
plate
Remove
screw
Remove the shipping pad inside the air
B
conditioner next to the compressor.
Carefully slide the air conditioner back into
C
the case. Make sure that the tubing on the
unit does not touch the wall case and that the
case installation is secure.
12
D
E
F
Remove
shipping pad
G
Reinstall the locking plate with the tab
behind the wall case flange. Tighten
the screw.
Attach the power cord to the base pan
with the clamp.
When the wall outlet is to the left, extend the
cord under the unit and hold it in place with
the clamp.
Clamp
Attach the front grille. An opening for
the power cord is on the bottom of the
front grille.
Base pan
Power cord
Clamp
Power cord