Assembly - Epic A17u Bike User Manual

ASSEMBLY

•• To watch an assembly
video, go to
http://productvideo.co/
assembly/dsg/epic or
use your mobile phone
or smartphone to read
the QR code with an
application such as
ShopSavvy.
•• Assembly requires two persons.
•• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you  nish all assembly steps.
1. Set a sturdy piece of packing material under the
rear of the Frame (1). Have a second person
hold the Frame to prevent it from tipping
while you complete this step.
Identify the Rear Stabilizer (3), which has a
Leveling Foot (29) on each end. Orient the Rear
Stabilizer as indicated by the sticker so that the
welded tubes are in the location shown.
Attach the Rear Stabilizer (3) to the Frame (1)
with two M10 x 105mm Screws (76).
Remove the packing material.
2. Set a sturdy piece of packing material under the
front of the Frame (1). Have a second person
hold the Frame to prevent it from tipping
while you complete this step.
Orient the Front Stabilizer (2) as shown.
Attach the Front Stabilizer (2) to the Frame (1)
with two M10 x 105mm Screws (76).
Remove the packing material.
•• Left parts are marked “"L”" or “"Left”" and right parts
are marked “"R”" or “"Right.”"
•• To identify small parts, see page 5.
•• In addition to the included tool(s), assembly
requires the following tools:
one Phillips screwdriver
Assembly may be easier if you have a set of
wrenches. To avoid damaging parts, do not use
power tools.
1
1
29
2
Wheel
76
2
6
3
29
76
Welded
Tubes
1