Zanussi ZDF3023 User Manual page 13

Problem
Limescale particles on the
dishes.
Whitish streaks and stains
or bluish layers on glasses
and dishes.
Dry water drop stains on
glasses and dishes.
The dishes are wet.
The dishes are wet and
matt.
Activating the rinse aid dispenser with the
multitab function activated
The appliance must be in setting mode.
Refer to 'SETTING AND STARTING A
PROGRAMME'.
www.zanussi.com
Possible cause
The spray arms could not turn freely.
The quantity of detergent was not
sufficient.
There was no detergent in the deter-
gent dispenser.
The salt container is empty.
The set level of the water softener is
incorrect.
The cap of the salt container is loose.
The released quantity of rinse aid is
too much.
The quantity of detergent was too
much.
The released quantity of rinse aid
was not sufficient .
The quality of the detergent can be
the cause.
The programme had no drying phase. Set a programme with the drying
The rinse aid dispenser is empty.
The quality of the rinse aid can be the
cause.
The quality of the combi detergent
tablets can be the cause.
Make sure that the position of the
items in the baskets is correct and
does not cause the blockage of the
spray arms.
Make sure that you add the correct
quantity of detergent in the dispenser
before you start a programme.
Make sure that you add detergent in
the dispenser before you start a pro-
gramme.
Make sure that there is dishwasher salt
in the salt container.
Make sure that the set level of the wa-
ter softener agrees with the water
hardness in your area.
Tighten the cap.
Decrease the released quantity of
rinse aid
.
Make sure that you add the correct
quantity of detergent in the dispenser
before you start a programme.
Increase the released quantity of rinse
aid.
Try a different brand of detergent.
phase.
Make sure that there is rinse aid in the
rinse aid dispenser.
Try a different brand of rinse aid.
• Try a different brand of combi deter-
gent tablets.
• Activate the rinse aid dispenser and
use the rinse aid together with the
combi detergent tablets.
1. Make sure that the programme marker on
the programme knob is aligned with the off
position.
2. Press and hold Start. At the same time turn
the programme knob counterclockwise until
the programme marker is aligned with the
first programme on the control panel.
Possible solution
13